If you’re like most people, you probably don’t think about your garage door sensor until it stops working. When that happens, you have to figure out how to install a garage door sensor. Luckily, this is a process that is relatively simple and can be done in just a few minutes. In this blog post, we will walk you through the steps of installing a garage door sensor. We will also provide some tips on how to choose the right sensor for your needs.
What is a garage door sensor?
A garage door sensor is a safety device that is used to prevent the garage door from closing if there is an object in the way. The sensor consists of two parts, an emitter and a receiver. The emitter sends out an infrared beam, and if the beam is interrupted by an object, the receiver will send a signal to the garage door opener to stop the door from closing.
Why do I need a garage door sensor?
The sensor is a vital part of your garage door opener system. It is there to protect you, your family, and your belongings from being crushed by the garage door. Without it, you would have to constantly be on guard whenever you are using your garage door, which would be very inconvenient.
How do I choose the right door sensor?
There are a few things you need to consider when choosing a door sensor. First, you need to decide what type of sensor you want. There are two common types of sensors, wired and wireless. Wired sensors are easier to install but they can be more difficult to troubleshoot if there are problems. Wireless sensors are more expensive but they offer more flexibility in terms of installation and troubleshooting.
Second, you need to determine the range of the sensor. The range is the distance between the emitter and receiver. Most garage door sensors have a range of about six feet, but some models can have a range up to twelve feet. Choose a sensor with a range that is appropriate for your garage door.
Third, you need to decide what type of power source you want for your sensor. Most sensors use batteries, but some models can be hardwired into your garage door opener system. If you choose a battery-powered sensor, make sure to get one that uses long-lasting lithium batteries.
How to install a garage door sensors with simple steps?
Installing a door sensor is a relatively simple process. First, you will need to mount the emitter and receiver units on either side of the garage door opening. Make sure that the units are level with each other and at the same height. Next, you will need to connect the two units with an infrared beam. You can do this by aligning the emitters and receivers and then pressing the “test” button on the receiver unit. Once the beam is interrupted, the receiver will send a signal to the garage door opener to stop the door from closing. Always call garage door services provider for help.
Thanks for reading!